AquaShield - Pool enclosure specialists - Installation Instructions

We swim yesterday for the first time this year. The water was 78 degrees and the pool enclosure mellowed out at 107. It was great. We don't have a pool heater. Just the enclosure and we also purchased a solar blanket that helped increase the water temperature a little. First swim April 5 2009, not bad for NC and no heater. Thanks for all your help with ordering and installation.
Cheryl & Carrie
Pittsboro, NC

Installation Instructions

Aqua Shield™ Enclosure arrives fully assembled and consists of a set of tracks, complete frame sections, and a set of end panels, one with door and all necessary hardware.

Aqua Shield™ Telescopic models Installation

   1. Mount track to ground surface.

   2. Place sections on track.

   3. Secure with safety hook.

Aqua Shield™ Hard Top Safety Cover arrives fully assembled and is easy to install!

Step 1: Find two parallel lines around the area you wish to enclose. Place the section panels so the screw hole in the legs lines up evenly with the parallel lines

Step 2: Mark holes, four per section and remove enclosure. Drill and install anchors.

Step 3: Install the enclosure one section at a time and fasten to the ground. Place the end panel over the section panel. Line up the holes and insert quick release pins.

Tel. (800) 613-3339
E-mail: info@aquashield.com